![]() |
John VanDyk has been innovating with information technology for more than 20 years. Read more... |
EnGenius ECB9500 firmware 2.3.3 enables SNMP monitoring
Submitted by John on Thu, 2012-11-01 09:07
I've been using the EnGenius ECB9500 wireless access point quite a bit. It has a lot going for it: small in size, power-over-ethernet, low cost.
One thing that has been a thorn in my side is that up til now, SNMP monitoring has been difficult because the built-in firewall rejects packets that are not from the same subnet that the IP of the WAP is on. Naturally my monitoring lives in the server room which is on a different subnet.
The firmware changelog notes that this was fixed in 2.3.0:
Add SNMP management IP. (If IP is set to 0.0.0.0, will allow any IP to access DUT via SNMP; otherwise only allow the specific IP to access DUT.)
Before:
After:
Topic:
- Log in to post comments